Placer County Unincorporated, California · General provision
17.54.120(G), 17.54.120(H)(1)(d)
Single FamilyAll Placer County Unincorporated districts0
Dimensional standards
Density
- Maximum units
- 4
Housing
- Two-family
- by_right
- Three-family
- by_right
Extracted standards
2 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Density
- Maximum units for duplexTwo-family dwellingTwo dwelling units in one building — a duplex./triplexThree-family dwellingThree dwelling units in one building — a triplex./fourplex4 units
the maximum density for a duplex, triplex, or fourplex in RS shall be up to four units per parcel of the minimum and maximum lot area required Section 17.50.010.
- Dwelling unitDwelling unitOne independent home: its own kitchen, bathroom and entrance. equivalency based on bedrooms
Within the C1, C2, CPD, MU, RS, RM zoning districts, the allowed number of dwelling units shall also be based on the number of bedrooms in each unit, as shown in the table below.
From the ordinance
the maximum density for a duplex, triplex, or fourplex in RS shall be up to four units per parcel of the minimum and maximum lot area required Section 17.50.010... a residential project, within the residential single-family (RS) or multifamily district (RM) of four or less base units shall be eligible for a density bonus of up to 100% above the maximum density allowed by the general plan and zone district, if the proposed project is served by municipal sewer and water, and located within a half mile from transit.