Placer County Unincorporated

Minimum Lot Area: a. Airport Site and Operational Areas: Twenty acres... b. Other Airport Facilities: Forty thousand square feet... Minimum Lot Width: Five hundred feet for an airport site... 135 feet for the sites of other buildings...

Five acres, except where a smaller parcel is authorized by way of the conditional use permit approval process... Two hundred feet... No more than 75% of the area of the site shall be covered by buildings, structures, or other impervious surfacing such as paving. ... Fifty feet... A minimum of 25% of the total area of each project site shall be improved with landscaping.

Minimum Lot Area: Five acres... Minimum Lot Width: Two hundred feet... Retail trade uses shall not exceed 20% of the developable area... Service uses shall not exceed 20%... No outdoor storage...

The industrial district is intended for a wide range of industrial activities including manufacturing, assembly, wholesale distribution, and storage. ... Crop production A, Industrial subdivisions A, ...

No more than 75% of the area of the site shall be covered by buildings, structures, or other impervious surfacing... Fifty feet, except that higher buildings are allowed where...

Ten thousand square feet... Sixty feet... The percentage of total site area that may be covered by buildings or structure. Parking structures are excluded from lot coverage as long as overall coverage does not exceed 75% with 15% of the site devoted to landscaping.

Twenty thousand square feet... Eighty feet... Parking structures are excluded from lot coverage as long as overall coverage does not exceed 75% with 15% of the site devoted to landscaping.

The purpose of the residential-agricultural (RA) zone district is to stabilize and protect the rural residential characteristics of the area to which it is applied and to promote and encourage a suitable environment for family life, including agricultural uses.

Ten acres... Two hundred feet... The maximum density for single-family dwellings in the RF zone shall be one unit per parcel of the minimum lot area required by subsection C of this section

Three thousand five hundred square feet for residential uses, 10,000 square feet for other allowable uses

Any residential multifamily development or the residential component of a mixed-use or live/work project within the RM30 zone district shall be established at a minimum density of 20 units per acre and maximum density of 30 units per acre.

The residential single-family district is intended to provide areas for residential development characterized by attached or detached single-family homes in standard subdivision form.

The purpose of the specific plan (SPL) district is to allow unique zone districts to be established consistent with an adopted specific plan, providing more flexibility in the designation of allowable uses, development standards, and other regulations than would be possible through application of other base and combining zone districts.

The requirements of Sections 17.52.020 through 17.52.140 apply to proposed land uses in addition to all applicable requirements of Sections 17.08.010 through 17.48.010 (Zone district regulations), Article 17.54 (General Development Regulations) and Article 17.56 (Specific Use Requirements) of this chapter.

The purpose of the aircraft overflight (-AO) combining district is to regulate land uses in the vicinity of public airports and below areas where aircraft perform approach and departure maneuvers

Maximum building height: 30 feet on lots of less than 20,000 square feet; 36 feet on lots that are 20,000 square feet or larger. Side setbacks shall be minimum five feet—one story; minimum seven and one-half feet—two or more stories.

conditional or minor use permit approval (Section 17.58.130) shall be required for all uses.

The front and street-side setbacks shall be a minimum of twelve and one-half (12.5) feet for any portion of a structure, but no less than 20 feet to the face (vehicle entrance) of any garage or carport and outside of a minimum twelve and one-half (12.5) foot multi-purpose easement or public utility easement that is adjacent to any public roadways, streets or driveways. The side setbacks shall be a total of 15 feet, minimum five feet to any structure for both sides.

The number shall mean the maximum number of dwelling units per acre allowed in the designated area. ... -DL 0 prohibits residential uses.

No construction, renovation, remodeling, reconstruction, demolition, or other alteration of a building, structure or site (see Section 17.52.070(D)(3)), including any change in the exterior appearance of an historic building shall occur within a design review combining district before obtaining design review approval as required by this section.