Dimensional standards
Servicing
- Applies near
- Fentress Airfield overlay districtOverlay districtA second set of rules laid over the base district, adding requirements without replacing it.
- Geographic extent
- Applies to motor vehicle repair facilities in business zoning districts other than those within the Fentress Airfield overlay districtOverlay districtA second set of rules laid over the base district, adding requirements without replacing it..
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Bay and garage doors orientation
Whenever physically possible, bay and garage doors shall face interior lots. If the facility is to be located on a corner lot, bay and garage overhead doors shall face the public street having the lowest traffic counts.
- Buffer yardYardThe open space left between a building and its lot line — the space a setback creates. width when doors face street15 ft
A fifteen foot vegetated buffer yard approved by the director of development and permits, or designee, shall be provided in cases where the bay or garage overhead doors must face a street.
- Fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. for outside storage6 ft
The outside overnight storage area shall be completely encircled by a six-foot fence consisting of opaque materials approved by the zoning administrator.
- Maximum outside overnight storage area percentage10 pct
The outside overnight storage area shall not exceed 10% of the total area of the parcel or 20,000 square feet, whichever is less.
- Maximum outside overnight storage area square footage20,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
The outside overnight storage area shall not exceed 10% of the total area of the parcel or 20,000 square feet, whichever is less.
From the ordinance
The following regulations shall be considered minimum standards for motor vehicle repair facilities (SIC 75) to be applied in addition to all other use and development criteria...