zoneoptics
Riverside County Unincorporated, California · District

PA-31

Planning Area 31
ResidentialSingle FamilyAll Riverside County Unincorporated districts0

Dimensional standards

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
5,000 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
50 ft
Minimum frontageFrontageThe length of a lot line that touches a public street.
45 ft
Minimum lot depth
80 ft

SetbacksSetbackThe distance a building must be held back from a lot line.

FrontSetbackThe distance a building must be held back from a lot line.
15 ft
RearSetbackThe distance a building must be held back from a lot line.
20 ft
SideSetbackThe distance a building must be held back from a lot line.
5 ft
Street sideSetbackThe distance a building must be held back from a lot line.
10 ft

Height & bulk

Maximum lot coverageLot coverageThe share of a lot that buildings may cover, as a percentage.
50%

Extracted standards

1 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

  • Maximum encroachment into side/rear yards2 ft

    Chimneys and fireplaces shall be allowed to encroach into side yards a maximum of two feet.

From the ordinance

Lot area shall be not less than five thousand (5,000) square feet... Side yards on interior and through lots shall be not less than five feet in width... In no case shall more than fifty (50) percent of any lot be covered by buildings for lots with one-story buildings
17.73.070