zoneoptics
Riverside County Unincorporated, California · District

PA-35

Planning Areas 35, 37 and 40
ResidentialSingle FamilyAll Riverside County Unincorporated districts0

Dimensional standards

PA-35 lot requirementsSTREETSTREETbuildable areaFront 12 ftRear 20 ftSide 4 ftStreet side 9 ftMin width 50 ftMin depth 100 ftMIN LOT AREA6,000 sq ftMIN FRONTAGE50 ft
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
6,000 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
50 ft
Minimum frontageFrontageThe length of a lot line that touches a public street.
50 ft
Minimum lot depth
100 ft

SetbacksSetbackThe distance a building must be held back from a lot line.

FrontSetbackThe distance a building must be held back from a lot line.
12 ft
RearSetbackThe distance a building must be held back from a lot line.
20 ft
SideSetbackThe distance a building must be held back from a lot line.
4 ft
Street sideSetbackThe distance a building must be held back from a lot line.
9 ft

Extracted standards

2 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

  • Maximum encroachment into side/rear yards2 ft

    Chimneys, air conditioning units, and fireplaces shall be allowed to encroach into side yards (on the non-gated side) and rear yards, a maximum of two feet.

Parking

From the ordinance

Lot area shall be not less than six thousand (6,000) square feet... The front yard for living areas and porches shall be not less than twelve (12) feet... Side yards on interior and through lots shall be not less than four feet in width.
17.73.110