Riverside County Unincorporated, California · General provision

17.111.030

Multi FamilyAll Riverside County Unincorporated districts0

Dimensional standards

Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Density

Lot area per dwelling unit: 3,000 sq ft

Setbacks

Front: 20 ft
Rear: 10 ft
Side: 5 ft

Servicing

Applies near: Specific Plan No. 362 (Panorama)
Geographic extent: Planning Areas 5, 6, 7, 8, 9, 10, 12 and 13 of Specific Plan No. 362 (Panorama)

Uses

Permitted by right1

multi-family residential uses per Article VIIId, Section 8.91 (except 8.91 c, d, e, f(1))

Extracted standards

2 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

Front setback with side-loaded garage15 ft
front yards shall be not less than fifteen (15) feet where side-loaded garages are used and adequate off-street vehicle storage is provided.
Side setback on corner/reversed corner lots10 ft
side yards on corner and reversed corner lots shall be not less than ten (10) feet from the existing or future right-of-way or from any future right-of-way as shown on any specific plan of highways, whichever is nearer the proposed structure.

From the ordinance

The minimum overall area for each dwelling unit, exclusive of the area used for commercial purposes and area set aside for street rights of way, but including recreation and service areas shall be three thousand (3,000) square feet. ... The front yard shall be not less than twenty (20) feet ... Side yards on interior lots shall be not less than a width of five feet. ... The rear yard shall not be less than ten (10) feet.
17.111.030

Use details

{
  "dropped_conditions": {
    "prohibited_uses": [
      "uses permitted pursuant to Section 8.91 c, d, e, and f(1)"
    ]
  }
}